"Retake Fort Darwin" mission map not loading properly

[F-Lambda]

 

Map Name

MAPS/MISSIONS/UNIQUE/I21_UNIQUE_MAPS/MERCY_ISLAND/LT_HARRIS/FORTDARWIN_ATTACK.TXT

 

Description

The map for Retake Fort Darwin is not loading properly. There are no bombs to activate, and only the first section of map loads in.  The ally pets load in fine, though.

When I load into the map, instead of looking like a normal Arachnos base (dark tech base look), the whole area is covered in a white fog, with occasional patches of blue where you can see through the walls (see attached picture). Only half of the dialogue between Harris and the boss runs, and there is a single group of enemies down the hallway to the right. There are no interactables aside from the three enemies, and only a small section of hallway (see attached picture of map).

Edited August 20, 2019 by F-Lambda

[garvisdol73]

Hi.  Did anything ever happen with this?  I'm getting the same problem, did a search and found your thread.

 

Edit: Just realized that the "end" of what I was getting had a door.  It wasn't marked as an elevator, but was one.

Edited December 25, 2019 by garvisdol73
found new infos

[F-Lambda]

2 hours ago, garvisdol73 said:

Hi.  Did anything ever happen with this?  I'm getting the same problem, did a search and found your thread.

 

Edit: Just realized that the "end" of what I was getting had a door.  It wasn't marked as an elevator, but was one.

Yeah, I eventually found the unmarked elevator also. Still weird that it loads as a white mist, though.