Help with $Target location bind

[MightyBob]

I'm trying to create a bind that shows a targets location in broadcast i.e. Babbage. I would like it to be generic so it can be used for Kronos Titans, Babbage, etc. I can get it to display both name and location but not in the right order. I know binds work in reverse order and that is causing me a problem with $Target due to the $$ designating an additional command.

 

If I use /bind numpad1 "broadcast $Target$$loc" then I get the location on one line followed by the target name. If I reverse the two I get "Unknown command $Target".

 

Any suggestions? I'm sure someone has this already but I'm stumbling over it.

 

Thanks in advance.

[Captain Fabulous]

Try /bind numpad1 "broadcast $target $loc"

Edited May 13 by Captain Fabulous

[MightyBob]

That was it. Thank you very much!

[SeraphimKensai]

For future reference the $$ acts sort of as a line break separating commands, so that's why your original version had issue.

[Psyonico]

1 hour ago, SeraphimKensai said:

For future reference the $$ acts sort of as a line break separating commands, so that's why your original version had issue.

Expanding on this, technically you only needed 1 command to do your bind, a /broadcast. The $$ basically says “now run this 2nd slash command”