The Trouble with slotting the Critical Strikes ATO…

[DarknessEternal]

4 hours ago, WuTang said:

Sorry, just making sure I'm reading the TW chart correctly. Rend has the highest chance to proc for a ST attack, at 90%?

Only outside Momentum.

[WuTang]

13 hours ago, DarknessEternal said:

Only outside Momentum.

 

Well I mean what's 1%? With momentum it's 89%, unless I'm looking at it wrong.

[aethereal]

Just to be sure, your PPM calculation includes the effects of the local recharge that the ATO2 itself brings into the power?

[The Trouble]

5 hours ago, aethereal said:

Just to be sure, your PPM calculation includes the effects of the local recharge that the ATO2 itself brings into the power?

It should, for the most part.  But admittedly, the first percentages were typed-in rather than made by formula (bad practice, I didn't plan for how big this was).  This would mean my Titan Weapons with Momentum numbers in the post are still off...

 

Everything in my sheet is now fully formulaic, and definitely includes the local recharge... but I clearly need to update every table in the post.  I'll fix everything later today (Done!). Huge thanks!

Edited Sunday at 06:16 PM by The Trouble
Revisions made to OP

[WuTang]

Mkay, how do we get this thing pinned??

 

This is too good not to have at the top!

 

Thank you @The Trouble

[Maelwys]

8 minutes ago, WuTang said:

Mkay, how do we get this thing pinned??

Paging @GM_GooglyMoogly

 

[GM_GooglyMoogly]

Sorry, no can do, Boo.

 

Pins have to go through those with higher authority and they have become less inclined to do so over the last few years.  In fact, we need to go through and unpin some stuff that is no longer relevant or accurate.

[Lockpick]

Kudos and thank you @The Trouble!  I always enjoy reading posts that try to shed light on the math, since I am horrible at it.  I usually put that ATO in the 1st or 2nd power selected because I never knew how it worked, so put it in the lower damage powers.  At least now I can come back to this thread for some info for new builds.  Now to figure out a way to bookmark this thread...